Stitching Standard practices.

In most cases, we stitch the suits as per the catalog image. However, some variances might occur due to the reasons listed below. You can always email your stitching specifications to stitching.cs@sanaullastore.com

• As per standard practice, we do not apply lining to the sleeves of see-through suits unless specified by the customer. If you prefer your suit's sleeves to be fully lined, please mention this in the order comments on the checkout page.
  
  
• If the length of the sleeves is not specified by the customer, we stitch full sleeves with the suit even if the catalog image shows the suit to be sleeveless, having half, or three-quarter sleeves.
  
  
• If articles are embroidered or embellished shirt backs or if the fabric is too delicate then a zipper can not be added to it even if the customer requests for one.
  
  
• We do not stitch deep necks from front or back, and short blouses that show mid-riff even if they are shown in the catalog image. (if you want to get deep necks stitched, please do email us).
  
  
• The shirt length is subject to vary by 1 to 2 inches as per fabric and embroidery of the suit.
  
  
• Normally our chiffon, organza, net, etc suits are fully lined even if they seem see-through in the catalog image. For instance, the shirt back of the following suit will be fully lined and not see-through. If the customer asks to make it see-through via email only then it will be stitched like the image.
• If there is a net or chiffon (or any see-through fabric) used to make a lehenga or maxi, the panels stitched together are not over-locked as the white thread visible underneath does not look good. The following suits lehenga panels will not good if over locked as their stitching would be visible.

• As per standard practice, we do not apply any additional embellishments (pearls, laces, etc) to the long side (maatha Patti) of the dupatta. If the brand has provided embellishments for all four sides of the dupatta, we apply them to all four sides.
• But if the catalog image shows laces, tassels, etc on all four sides that have not been provided by the brand, then we only stitch it to the short sides (pallus) of the dupatta.
• If you select “straight/plain” option in the sleeves style then borders provided by the brand will be applied to the sleeves, if a brand has not provided any borders then additional laces or accessories will not be applied.
• If you select “straight” in daaman style then borders provided by the brand will be applied to the shirt daaman, if a brand has not provided any borders then additional laces or accessories will not be applied.
• If you select “straight/plain” in trouser style then borders provided by the brand will be applied to the trousers bottoms, if a brand has not provided any borders then additional laces or accessories will not be applied.
• If both measurements are provided, then only “Chalks/Side Slits (from armhole to start of chalk)” will be followed, and “Chalks/Side Slits (from the start of chalk to daman)” will be disregarded.
• If “bell sleeves” are selected, then the sleeve's bottom would be around 16 to 20 inches as per fabric availability, despite the measurements shared in the form.
• If the trousers or sleeves bottom exceeds the provided border width, our team will contact you regarding the application of the borders.